• Easily used staff right out of the box, rapid test times.

  • Instant indication of condition for motor bearings, gears, compressors, slewing rings, hoists, winches...

  • Plan maintenance and have the spares available on time. Minimise off-hire and demurrage.

Wear Metal Analysis

ANALEX fdMplusANALEX fdMplus
Developed in co-operation with Shell Marine Lubes, the fdMplus implements a skill set in sensitive magnetometry into a design suitable for On-Site applications.  Sensitive to very low ferrous contaminations levels (<1 micron) and reporting directly in ppm for comparison with laboratory test results. Suitable for use on 50 or 5 ml oil and pre-prepared grease samples. Test time typically <10 seconds per sample.

Click here for more information about the ANALEX fdMplus (see also ANALEX rpd for preparation of ferrographic slides).


ANALEX pqFANALEX pqF
The ANALEX pqF brings PQ wear metal analysis capability to On-Site oil analysis. Suitable for a wide variety of in-service oil, grease and QC samples, it detects iron contamination and reports directly in the industry standard PQ Index. Provided with integral calibration sample. A derivative developed with ExxonMobil is available as the MSA scrapedown oil analyser for use on marine two stroke scavenge oil samples under their feed rate optimisation programme. Typical test time < 20 seconds per sample.

Click here for more information about the ANALEX pqF.


ANALEX pqLANALEX pqL
NEW -
 The new ANALEX pqL is the latest development of a widely accepted ANALEX pq laboratory instrument range. Enhancements include greatly improved reproducibility at low pq levels (<25 PQ), reduced footprint, much faster (0.5X) cycle time and better auto-calibration. Accepts used and in-service oil and pre-prepared grease samples. Reports results in PQ Index and is suitable for connection to laboratory LIMS systems and remote operation. 

Click here for more information about the ANALEX pqL.


ANALEX rpd

ANALEX rpd
NEW - Used to prepare cleaned, graded ferrographic samples for subsequent microscopic examination. The ANALEX fdMplus, pqF and pqL will all easily identify used or in-service oil samples with high iron levels. Further examination of the particle size and shape can indicate the form and progress of machine wear e.g. cutting, sliding, fatigue etc. The ANALEX rpd in particular compliments the new ANALEX pqL with rapid preparation of ferrographic slides from an initial dirty sample of used lubricating oil or grease.   

Click here for more information about the ANALEX rpd (see also the new ANALEX pqL).


Hydraulic Particles Test KitHydraulic Particles Test Kit

A small self contained kit specifically aimed at basic On-Site care of hydraulic systems. Quickly identify hydraulic system contamination by a variety of metallic and non-metallic contaminants and gauge the suitability for continued use or need for additional filtration. 

Click here for more information about the Hydraulic Particles Test Kit.


Wear Metals

Latest News

Importance of Bunker Fuel Sampling
Testing bunker fuel, the fuel oil used by ocean going ships or the tanks they’re stored in, is vit... Read More...
The Problems Delaying the Switch to LNG in Shipping Fuel
The shipping industry has found itself doing a U-turn when it comes to the use of LNG as shipping fu... Read More...
Lowering Sulphur Emissions with Scrubbing Systems
New emissions rules being introduced in 2015 means ship owners worldwide are faced with a choice on ... Read More...